|
Mitigation
Information for Homeowners
What
are earthquakes and what causes them?
Regional
information about earthquakes for the Cascadia Region
Homeowner
mitigation information
Information about ash fallout from volcanic eruptions
Homeowner
mitigation information
Basic
Preparedness
What to do During and After the Earthquake
Mitigation Measures for
Your Home
Getting the Work Done
Safety Outside The Home
Other Resources
Steps
to Prepare Yourself and Your Family for an Earthquake
Basic
Preparedness
1.
Store enough food, water and medical supplies for 3 days
The following is an exerpt from an informational
site from Humboldt State University in Northern Califonia:
"If a major earthquake knocked out your power, disrupted
your water supply and damaged your home, could you cope on your
own for three days? A major earthquake disaster would overwhelm
local law enforcement, fire, and emergency medical personnel and
resources. If transportation and communication channels are damaged,
getting help may take hours or days. When a city cannot adequately
meet demands for help, it requests assistance from neighboring
cities and/or the county. If the county cannot adequately assist,
the request is passed on to the State of Office of Emergency Services
(OES). Finally, if state resources are insufficient, the Governor
can ask the President to declare the county(ies) a Major Disaster
Area and release federal assistance. This process may take days."
A complete list for a disaster
supply kit is available from the Red Cross.
2.
Prepare a home earthquake plan
How
to prepare a home earthquake plan
How
to prepare a family distaster plan
-
What
To Do During And After the Earthquake
1.
Know what to do during an earthquake
The following is an exerpt from
the Humboldt
State University in Northern California:
The California Office of Emergency Services recommends:
If you are indoors, duck or drop down to the floor. Take cover
under a sturdy desk, table or other furniture. Hold on to it and
be prepared to move with it. Hold the position until the ground
stops shaking and it is safe to move. Stay clear of windows, fireplaces,
wood stoves, and heavy furniture or appliances. Stay inside. Outside,
you may be injured by falling glass or building parts. If you
are in a crowded area, take cover and stay where you are. Stay
calm and encourage others to do likewise.
If you are outside, get into the open, away from buildings, power
lines and trees.
If you are driving, stop if it is safe, but stay inside your car.
Stay away from bridges, overpasses and tunnels. Move your car
as far out of the normal traffic pattern as possible. Avoid stopping
under trees, light posts, power lines or signs if possible.
If you are in a mountainous area, or near unstable slopes or cliffs,
be alert for falling rock and other debris that could be loosened
by the earthquake.
For a brief summary table
about what to do during an earthquake, visit the the Pacific
Northwest Seismograph Network site.
2.
What to do after an earthquake
If you are at the beach. Move to higher ground as soon as the
shaking stops.
Check for injuries. Do not move a seriously injured person unless
they are in immediate danger of further injuries.
Check for hazards:
- Fire or fire
hazards.
- Gas leaks. Shut
off the main gas valve only if a leak is suspected or identified
by the odor of natural gas. Wait for the gas company to turn
it back on once the damage is repaired.
- Damaged electrical
wiring. Shut off power at the control box.
- Downed or damaged
utility lines. Stay away from downed lines, even if power
appears to be off.
- Fallen objects
in closets and cupboards. Displaced objects may fall when
you open the door.
- Downed or damaged
chimneys. Approach chimneys with caution. They may be weakened
and could topple during an aftershock.
- Your telephone.
Make sure each phone is on its receiver. Telephones off the
hook tie up the telephone network. Use only in the event of
a lift-threatening emergency
- Clean up. Potentially
harmful materials and/or medicines may have spilled.
- Expect aftershocks.
Most of these are smaller than the main earthquake. Some may
be large enough to do additional damage to weakened structures.
- Listen to the
radio. Radios are your best source of damage reports and other
information. Search the radio dial for Emergency Broadcast
Stations near you which are on the air and able to give information.
- Anticipate tsunamis.
To learn more about tsunami risks, visit our tsunami
page.
For a brief summary
table about what to do after an earthquake, visit the the Pacific
Northwest Seismograph Network site.
Mitigation
Measures For Your Home
1.
Protect Your Belongings
The following is a list of mitigation measures that you
can take in your home to protect property damage from occurring
during an earthquake:
Move heavy items, such as pictures, mirrors or tall dressers,
away from your bed.
Secure tall furniture and bookcases with lag bolts to wall studs.
Add lips to shelves to prevent costly items from sliding off their
supports.
Put
latches on cabinet doors, especially at home in your kitchen and
at work or in school laboratories.
Fasten
heavy or precious items to shelves or tables. Secure file cabinets,
computers, televisions and machinery that may move during an earthquake.
Use easy tack putty to secure fragile objects on shelves.
Store
potentially hazardous materials such as cleaners, fertilizers,
chemicals, and petroleum products in appropriate containers and
in sturdy cabinets fastened to the wall or floor.
Fasten
heavy objects to the building structure and not just to a movable
wall in your office. Ask a carpenter or an electrician to determine
whether light fixtures and modular ceiling systems are securely
fastened.
Be
sure your water heater is fastened to the wall studs and that
all gas heaters and appliances are connected to the gas pipe through
flexible tubing (Figure 1). If you use propane gas, be sure the
storage tank is secured (Figure 2).
Secure
your wood stove to wall or floor studs (Figure 3). Make sure you
have a fire extinguisher close at hand.
2.
Directions to secure your water heater, wood stove and propane
tanks.
-
- Figure 1. Secure
your water heater. Wrap a 1-1/2-inch-wide, 16-gauge-thick
metal strap (A) around the top of the water heater and bolt the
ends together. Do the same about 1/3 of the way up the side of
the water heater. Take four lengths of EMT electrical conduit,
each no longer than 30 inches. Flatten the ends. Bolt one end
to the metal strap as shown (B). Screw the other end to a 2-inch
by 4-inch stud in the wall using a 5/16-inch by 3-inch lag screw.
Be sure a flexible pipe (C) is used to contact the gas supply
to the heater. California Office of Emergency Services

Figure
2. Stove Anchorage. For stove on a brick hearth, anchor stove
with 3/8-inch diameter bolt (A) through 1/2-inch hole to new brick
(B). Grout brick to existing hearth with 1-inch new grout (C). Alternatively,
build 8-inch square brick pad with grout pocket (D) at each leg.
Provide at least 1-inch grout all around leg, fill pocket completely
with grout. Provide sheet metal screws (E) at flue exit and between
stovepipe sections. Provide radiation shield with pipe clamp (F)
braced to wall using two Simpson WTT187 tension ties or equivalent
(G) attached to wall stud with 3/8-inch by 3-inch lag screws. California
Office of Emergency Services.

Figure
3. Propane Tank Anchorage. Mount tank on 6-inch thick concrete
pad (A) using four 1/2 diameter bolts (B) with 3-inch minimum embedment
into the concrete. Provide a flexible hose connection (C) between
the tank and the rigid supply line. California Office of Emergency
Services.
3.
Strengthen your home to reduce earthquake damage
NOW is
the time to evaluate your home and install strengthening measures,
before you forget and before the next earthquake. You can make these
changes yourself at relatively low cost if you have basic carpentry
skills. Otherwise, contact a licensed professional about making
the necessary changes to you home or office. Contact your local
building department to modify details to fit local building codes.
Specific
actions that can be taken are:
Bolting the wood frame to the concrete foundation can significantly
reduce earthquake damage.
Reinforcing the cripple walls between the foundation and the first
floor of a wood-frame house can significantly reduce earthquake
damage.
Securing your floor system.
Securing and reinforcing walls.
Securing roof and reinforcing chimneys.
An in-depth
Homeowner's
Guide to Earthquake Retrofit is available on-line at from the
Institute for Business
and Home Safety. This guide gives step-by-step illustrated instructions
on how to complete both structural and non-structural repairs detailed
in this section, as well as pricing estimates and equipment lists.
A
brief overview of important home mitigation actions to take
is available from the Federal
Emergency Management Agency's site.
Getting
The Work Done
How do
you locate professionals to advise you on the resistance of your
building to earthquake shaking? Who should perform the needed
construction?Civil and structural engineers and architects are
trained to provide such information about structures. Geologists,
foundation engineers, and geotechnical engineers are trained and
licensed to evaluate soil conditions and recommend appropriate
action. A contractor has to implement the detailed plans and specifications
prepared by an architect or engineer.
A good place to start
is to call a professional organization and ask about the types of
work that might be required; how to select an engineer, geologist,
or architect; and a list of members in your area.Contact several
firms or individuals to determine whether they do the types of work
you need. Make sure the firm has the necessary licenses and has
experience in strengthening structures to resist earthquake shaking.
Check to see how satisfied other clients were. Recognize that the
quality of the advice given and the work performed, as well as the
price you pay, may depend on the care you take in making your selection.
Become informed. Even
if you do not understand the technical details, ask enough questions
to understand the concepts and relative importance of the issues
involved. You have a right to understand what needs to be done and
why.
State and federal agencies
do not inspect individual buildings. Your local building department
may be willing to inspect your building, but they are not authorized
to recommend actions to be taken.
Information for this
section has been taken from Humboldt State University's on-line
publication: Living
on Shaky Ground: How to Survive Earthquakes and Tsunamis on the
North Coast of California.
Although
much of our time is spent in the home, a considerable portion is
spent outside the home. Some earthquake related questions that you
might want to ask are:
Is my workplace retrofitted for earthquakes?
Does my workplace have an training program or plan so that employees
know what to do in case of an earthquake?
Is my child's kindergarten, school or daycare facility retrofitted
for an earthquake, and are the care providers trained for an earthquake
eventuality?
-
Information about the
Homeowner's
Guide to Earthquake Safety from the California Seismic Safety
Commission is available on-line.
|